Jump to content

Recommended Posts

Как читать радио на FIS процессорах (Audi Navigation+)
Radio based on FIS module. You will need to read internal i2c memory to get original code.

Disconnect all cables from Clip.

Compare your radio board with following pinouts:
- http://forum.martech.pl/download/fis_type1.jpg
- http://forum.martech.pl/download/fis_type2.jpg
- http://forum.martech.pl/download/fis_type3.jpg
- http://forum.martech.pl/download/fis_type4.jpg

Clip Pinout:
Port2.1 - VCC ( +5V )
Port2.2 - SCL ( clock )
Port2.3 - SDA ( data input/outout )
Port2.7 - GND ( ground )

If you see Port2.1 on your connection photo:
Solder wires to radio board, connect RJ45 connector to the Clip
Use Direct Read and then Read Info button.
After short moment you will see original navigation code.

If you don not see Port2.1 on your connection photo:
Solder wires to radio board, connect 12V to the radio, turn it on and wait 30 seconds.
Connect RJ45 connector to the Clip, use Direct Read and then Read Info button.
After short moment you will see original navigation code.
 

x7VsbMYe17g.jpg

p24uLfo3m7I.jpg

9mxNuFM6gtM.jpg

sQXhyT9goAo.jpg

 

Мануал по ГУ Audi SymphonyAUDI_SYMPHONY_CQ-JA1920-24L.pdf

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...